Tool set

It is a tool set used in the workshop of Yusha Kobo.

Basic set (soldering set)

・ HAKKO FX600
http://www.hakko.com/japan/products/hakko_fx600.html
A stick-type soldering iron equipped with a temperature control function.

・ T18-D16
It is a trowel tip for FX600 with a flat tip.

・ HAKKO 633-01
https://www.hakko.com/japan/products/hakko_kote_board.html
Iron stand and iron tip cleaner for FX600. The cleaner comes with a wire type that does not require water addition (HAKKO 599B: https://www.hakko.com/japan/products/hakko_599b.html ).

・ Goot SE-06008
https://www.goot.jp/products/detail/se_06008
Lead-containing wire solder. The thickness is 0.8 mm. Flux attached type.

・ Goot CP-3015
https://www.goot.jp/products/detail/cp_3015
It is a solder sucking line. A copper mesh with powder flux attached. Cut it into short pieces and heat it with the solder to absorb the solder.

・ Goot BS-75B
https://www.goot.jp/products/detail/bs_75b
Flux for printed circuit boards. Flux is an additive that is attached to the part to be soldered to remove dirt from the processed part, reduce the surface tension of the solder, and facilitate soldering. Please use it when soldering surface mount ICs. A solid type flux is also attached to the attached wire solder.

All-in-one set (includes the following in addition to the basic set)

・ HOZAN P880
https://www.hozan.co.jp/catalog/Tweezers/P-880.html
General-purpose tweezers. Please use when soldering surface mount parts.

・ HOZAN P89
https://www.hozan.co.jp/catalog/Tweezers/P-89.html
Reverse action tweezers that close when released and open when picked. Please use it to hold parts that are difficult to hold by bending the lead wire during soldering.

・ HOZAN D-840-4
https://www.hozan.co.jp/catalog/tools/D-840.html
A nut driver that can hold M2 standard nuts that are often used in homebrew keyboards.

・ VESSEL 910 P.1-75
https://www.vessel.co.jp/product/screwdriver/detail/125744
A Phillips screwdriver that fits the +0 standard screws that are often used in homebrew keyboards. Since it has a thin shaft, it can also be used for assembling kits such as DZ60. Some kits do not support the +00 standard, so please prepare a precision screwdriver separately.

・ Goot YN-1
https://www.goot.jp/products/detail/yn_1
Nippers that can cut lead wires of electronic components.

Precautions

・ Since this product contains flammable liquid (flux), it may take some time to deliver to remote islands such as Okinawa Prefecture, islands, and some areas such as Hokkaido. Please note.